Blog

DMC Detailed Write up - Ford Focus RS White

Posted on

0 Comments

Welcome to another write-up from me! This time a 60 Reg Ford Focus RS in White, I've done 3 Blue ones before so it was nice to do a White one, IronX alone is loads of fun on White for one thing!

Firstly please check out our other detailed write-ups, for a full list of cars please go here:

See Writeups

My customer only purchased this car a short time ago but wanted to treat it to some proper TLC as it's safe to say it's definitely never been detailed, and from the looks of it certainly not a tar remover and possibly spent a bit of time near an industrial estate I'd guess going by the fallout present.

The task was as follows:

  • Full Enhancement Detail for the Exterior with Crystal Rock wax upgrade
  • Interior deep clean and protect
  • Engine bay clean and protect

The car was dropped off on Friday afternoon and first up was the Engine bay

Using Meg's APC and Degreaser with various brushes (and a steam cleaner) I started from the top down and worked with the underside of the bonnet as it was clearly pretty dirty!

IMG_8555Medium.jpg

50/50 of the underside
IMG_8567Medium.jpg

IMG_8575Medium.jpg

Dirty left side
IMG_8570Medium.jpg

Right side nearly done
IMG_8578Medium.jpg

Left side started
IMG_8580Medium.jpg

303 Used
IMG_8558Medium.jpg

After 303 sprayed on the right side
IMG_8559Medium.jpg

Left - Before 303 sprayed
IMG_8560Medium.jpg

After 303 applied
IMG_8564Medium.jpg

Engine bay all done
IMG_8604Medium.jpg

IMG_8600Medium.jpg

IMG_8608Medium.jpg

Moving to the interior!

Here's how it started
IMG_8582Medium.jpg

IMG_8583Medium.jpg

IMG_8584Medium.jpg

IMG_8585Medium.jpg

Boot
IMG_8589Medium.jpg

Skirts / Sills
IMG_8592Medium.jpg

IMG_8594Medium.jpg

Mats
IMG_8591Medium.jpg

Mats were taken out, vac'd, steam cleaned and blasted with the Tornador with some Brisk. After this I applied GTechniq L1 to protect the fabric
IMG_8597Medium.jpg

I dusted down using some Surf City Dash Away to start with, this is a good cleaner and does leave a very dry grease free finish
IMG_8581Medium.jpg

I blasted all plastics and carpets with the steam cleaner then followed up with the Tornador with some AS Brisk loaded in the chamber for the carpets. All pedals, steering wheel etc were all deep cleaned in the same way and GTechniq I1 was applied to all interior carpets before putting mats back in. Sills were cleaned with Meg's APC and towel dried them.

Plastics were then all wiped down with 303 to add a nice satin / natural protective layer. I then gave the interior a quick blast with the Deodourizer although it was already a very pleasant place to be it's always good to make sure it gets into all the crevices and areas you can't reach.

A nice Cherry California scent air freshener was then added just to keep it smelling fresh for a few months at least!

IMG_8613Medium.jpg

IMG_8614Medium.jpg

IMG_8617Medium.jpg

IMG_8619Medium.jpg

IMG_8620Medium.jpg

IMG_8623Medium.jpg

That was me done for Friday night!

Up early to start again on Saturday, so the car was taken outside and here's how it was looking

IMG_8629Medium.jpg

IMG_8631Medium.jpg

IMG_8630Medium.jpg

IMG_8633Medium.jpg

IMG_8632Medium-1.jpg

IMG_8634Medium.jpg

IMG_8635Medium.jpg

IMG_8637Medium.jpg

IMG_8636Medium.jpg

First up it was snow foamed, rinsed and the wheels then cleaned with AS Smart wheels, a few brushes followed by IronX and Tardis.

IMG_8639Medium.jpg

I then hand washed the outside, rinsed off then set about getting the tar off! Sprayed Tardis on and left for a couple of minutes

IMG_8640Medium.jpg

IMG_8641Medium.jpg

IMG_8643Medium.jpg

After rinsing it all away I then set about using IronX on the rest of the car. I knew it would be bad as you could physically see the contamination on the paint but this was someting else!

IMG_8644Medium.jpg

IMG_8646Medium.jpg

IMG_8647Medium.jpg

IMG_8648Medium.jpg

IMG_8649Medium.jpg

IMG_8650Medium.jpg

IMG_8652Medium.jpg

IMG_8655Medium.jpg

IMG_8654Medium.jpg

IMG_8661Medium.jpg

IMG_8659Medium.jpg

IMG_8662Medium.jpg

IMG_8665Medium.jpg

IMG_8667Medium.jpg

Really starting now....
IMG_8668Medium.jpg

IMG_8669Medium.jpg

IMG_8670Medium.jpg

Wheels all clean
IMG_8678Medium.jpg

All rinsed off, then clayed with Zaino and some shampoo with water.

Lastly the car was dried off and taken inside
[IMG_8672Medium-1.jpg

The car was then taped up ready for maching, I ended up using Scholl S17+ with a Hex logic white pad and it was giving great correction

White is usually hard to get decent 50/50's but these show some good reslts
IMG_8682Medium.jpg

IMG_8684Medium.jpg

IMG_8685Medium.jpg

IMG_8690Medium.jpg

IMG_8694Medium.jpg

IMG_8700Medium.jpg

IMG_8699Medium.jpg

IMG_8701Medium.jpg

New pad brush from Meguiars
IMG_8702Medium.jpg

All polished
IMG_8704Medium.jpg

IMG_8703Medium.jpg

IMG_8706Medium.jpg

IMG_8722Medium.jpg

IMG_8725Medium.jpg

Wax for this car was Swissvax Crystal Rock - Still the nicest Wax I've ever used and always enjoy just how easy it goes on and off!

IMG_8730Medium.jpg

Tyres dressed with Pinnacle
IMG_8737Medium.jpg

FK was used on wheels, plus all the door shuts
IMG_8739Medium.jpg

IMG_8740Medium.jpg

IMG_8742Medium.jpg

All finished!
IMG_8797Medium.jpg

IMG_8743Medium.jpg

IMG_8746Medium.jpg

IMG_8745Medium.jpg

IMG_8751Medium.jpg

IMG_8750Medium.jpg

IMG_8755Medium.jpg

IMG_8753Medium.jpg

IMG_8758Medium.jpg

IMG_8768Medium.jpg

IMG_8757Medium.jpg

IMG_8763Medium.jpg

IMG_8765Medium.jpg

IMG_8771Medium.jpg

IMG_8772Medium.jpg

IMG_8775Medium.jpg

IMG_8780Medium.jpg

IMG_8784Medium.jpg

IMG_8785Medium.jpg

IMG_8790Medium.jpg

IMG_8789Medium.jpg

IMG_8791Medium.jpg

IMG_8795Medium.jpg

Thanks again for reading!

Add a comment:

Leave a comment:
  • This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Comments

Add a comment